Removing The Transit Bars; Commissioning Twindos - Miele WWG 660 Operating Instructions Manual

Before using for the first time

3. Removing the transit bars


Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washing
machine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in "Installation".
The following message appears in the
display:

Remove transit bars
 Confirm with the OK sensor.

4. Commissioning TwinDos

The UltraPhase 1 and UltraPhase 2
values are preset in the standard
settings and only need to be confirmed.
The following message appears in the
display:
 TwinDos
 Confirm with the OK sensor.
The following message appears in the
display:
Set now
 To set up TwinDos now, touch the OK
sensor.
 To postpone setup until later, touch
the  sensor until the following
appears in the display:
press OK to confirm.
20
and
Set later
Settings for compartment 
The UltraPhase 1 values are preset in
the standard settings.
 
Agent for 

 
 Confirm with the OK sensor.
 
Miele UltraPhase 1
 
 Confirm with the OK sensor.
The following appears in the display:
 Set the dosage. Observe water hardness
level
 Confirm with the OK sensor.
The dispensing quantity for
UltraPhase 1 for  (hardness range I)
is preset.
 
Per load
 
 Confirm the preset value with the
OK sensor. If you want to change this
value, use the  sensors and
confirm with the OK sensor.
UltraPhase 1
 Hardness level I
 Hardness level II
 Hardness level III
OK

OK
46 ml
OK
46 ml
58 ml
70 ml