Fault Messages After A Programme Has Been Cancelled - Miele WWG 660 Operating Instructions Manual

Problem solving guide

Fault messages after a programme has been cancelled

Problem

Check drainage. See


Water intake. See


 Service
Waterproof syst.
Turn off 

 Service Fault F
To switch off the fault message: Turn the programme selector to the  position to
switch the washing machine off.
64
Possible cause and remedy
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the filters and the drain pump.
 The maximum drain height is 1 m.
The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The drain pump is activated for 2 minutes. The washing
machine door is then released. Wait for the drain pump
to stop before switching the machine off.
The water protection system has reacted.
 Turn off the tap.
 Call Miele.
There is a fault.
 Disconnect the washing machine from the
electricity supply. Switch off at the wall and
withdraw the plug from the socket, or switch off
the mains circuit breaker.
 Wait at least 2 minutes before reconnecting the
washing machine to the electricity supply.
 Then switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact Miele.