Honeywell BW RigRat User Manual page 61

5. Press the RAEMet's base into place, and then turn the locking ring to tighten the connection.
Never force the connector in or out of the receptacle.
6. Tighten the locking ring until the RAEMet sensor is firmly seated. Do not turn the entire
RAEMet sensor.
If the RAEMet and RigRat's receptacle are not aligned properly, electrical connections will not be
made and the RAEMet sensor will not operate. Also, when the RAEMet sensor is not attached to the
instrument, make sure the cover is securely closed to keep moisture and debris from entering the
base.
Note: Do not remove the RAEMet sensor from the instrument while it is in operation.
Note: Keep strong magnets away from the RAEMet sensor. It contains a compass, and strong
magnetism can affect its accuracy.
BW RigRat User's Guide
IMPORTANT!
61