Table of Contents
Advertisement
Setting speed: [Speed]
Setting force: [Force]
There are two ways of selecting the pen force: One gives the settings for every 8 gf, the other finer settings
between 0 gf and -6 gf. Select the force according to the type of the pen. When selecting the force based on fine
settings, the function for selecting settings for all pen numbers at the same time is not available.
Select the desired pen number by pressing the
and
keys to select the plotting speed. Press the
Press the
key to go back to the previous display.
* If a pen number is not specified ([All] is displayed at the top right),
the same pen speed is set for all pen numbers.
Select the desired pen number by pressing the
Press the
and
Press the
Press the
* If a pen number is not specified ([All] is displayed at the top right),
the same pen force is set for all pen numbers.
Press the
key to adjust the pen force downward for fine settings.
The force can be adjusted downward from the current force within
a range of 0 6 gf (in increments of 2 gf).
* In the case above, [Force] (pen force) is set to [10 gf], and [Pre.] (fine adjustment) is
set to this value minus 2 gf, which is [8 gf].
To adjust the pen force upward, press the
stage higher, then press the
the desired force, press the
34
key. Press the
keys to select the pen force.
key to execute.
key to go back to the previous display.
key to adjust the force one
key to adjust it downward. After reaching
key to execute.
key to execute.
key.
Advertisement
Table of Contents
