Roland DPX-3700A User Manual page 16

key once to select the
Press the PAPER HOLD
position. Load the paper onto the drawing board
while the P APER HOLD LED is blinking.
key one more time.
Press the
PAPER HOLD
The P APER HOLD LED lights up and the paper
is secured in place.
If the Sheet Tears While Plotting...
If an edge of a loaded sheet does not lie flat, it may catch on parts of the pen carriage and tear during plotting.
If an edge of the sheet is not held perfectly flat by suction even after pressing the
sheet to be held, then secure the edge with commercially available drafting tape or the like.
If the sheet has been torn, then remove the sheet, taking care not to bend any of the parts on the pen carriage.
Bending of a pen carriage part may result in partially faint plots when the carriage is loaded with any type of
plotting implement other than a pencil.
When Plotting with an Oversize Sheet
1) When the screen at right is shown, press
[USER 1], [USER 2], or [USER 3].
The currently set coordinate values are displayed at this time.
2) Press the cursor keys and the
to the upper right edge of the sheet.
3) Press the key.
4) When the screen at right appears, the setting for user size has been
completed. This screen indicates that a sheet size of 500 mm x 300
mm has been set.
After a for example seconds, the following menu appears.
Three user sizes -- [USER 1], [USER 2], or [USER 3] -- can be set.
These settings remain stored in memory even after the power is
switched off.
2
4
key to move the pen carriage
Remove bubbles and wrinkles from the paper by
wiping with a dry cloth.
Set the paper size of the display menu to match
the size of the paper loaded in the DPX.
Top menu
Use or to select a size. Press
enable the setting.
to display either
6
3
5
Press the key.
Use to select [ISO-**],
[JIS-**], [ANSI-**], ([ANSI
ARCH-**],) [DIN-**],
[USER 1], [USER 2] and
[USER 3].
to
key to cause the
PAPER HOLD