Table of Contents
Advertisement
Correcting the distance
Use only gentle force to change the size of the paper. If you move the paper used for front-side plotting, the size of
the plotting on the front may differ slightly from that immediately after completion of plotting. Therefore, if you
execute reverse-side plotting in such a state, a discrepancy in alignment will result, giving you an inaccurate
plotting. Here, the difference between the distance recognized by the DPX and that sent by the computer is
corrected. The range within which correction can be made is 1%. The numerical values shown in the explanation
below are given as examples.
Correcting the distance for X axis: [X-Axis]
After setting the Y correction point
Correcting the distance for Y axis: [Y-Axis]
After setting X-axis distance alignment
With this the correction is completed if you are performing reverse-side plotting.
Main menu 1
While at the Y-axis distance
alignment setting screen,
press the
key once.
If a digitizing scope is being used, it should be removed from the pen stock before attempting to plot.
The values for the offset setting, axis compensation and distance compensation are ignored in any of the
following cases (meaning you will have to correct all the settings from the beginning):
• Immediately after turning on the power
• When changing the paper size
• When switching between front-side plotting and reverse-side plotting
• When selecting [No] in response to the message [Do XY-Adjust?]
The distance between the base point and the X correction point recognized by the DPX
will be displayed on at the upper left on the screen.
If you press the
or
distance set on the computer. Press the
Press the
key to continue with the setting of the correcting the distance for Y axis.
The distance between the base point and the Y correction point recognized by the DPX
will be displayed on at the upper left on the screen.
If you press the
or
key, the value displayed on the right will be the same as the distance
set on the computer. Press the
32
key, the value displayed on the right will be the same as the
key to execute.
key to execute.
Select [0] as the pen number.
Pressing the
pen (or digitizing scope) to the pen stock.
key returns the
Advertisement
Table of Contents
