Table of Contents
Advertisement
Calculating the number of steps for the hard clip, P1 default, and P2 default.
• RD-GL II
Hard Clip
40 ÷2) + 480)
LLx = (-1)
((x
LLy = (-1) ÷ (y
40 ÷2)
40 ÷2) - 480
URx = (x
40 ÷2
URy = y
* When note "*2" in the Plotting Area Chart on the
previous page applies (i.e., portrait orientation is
used), make calculations after swapping the values for
"x" and "y" in the table above.
• RD-GL III
Hard Clip
LLx = 0
LLy = 0
URx = x
40
URy = y
40
[Origin]
This moves the location of the origin. When RD-GL III has been chosen, no selection other than [LL] can be made.
DPX:
Sets the origin at a point slightly to the right of the center of the paper which was set using the paper size setting
menu.
Center: Sets the origin at a position located in the center of the paper which was set using the paper size setting menu.
LL:
Sets the origin at a position located at the lower-left point of the paper which was set using the paper size setting
menu.
[DPX]
(0, 0)
When [Guide] is selected using the [PaperSet] menu, the paper is shifted to the bottom left, and the DPX
decreases the plotting area proportionately.
For further details, refer to "5 Loading the Paper" on page 5.
P1, P2 Default
P1x = LLx + 800 + 960
P1y = LLy + 800
P2x = URx - 800
P2y = URy - 800
P1, P2 Default
P1x = 0
P1y = 0
P2x = URx
P2y = URy
[Center]
18
Y
Origin (0, 0)
X
P1
LL
Y
Origin (0, 0)
X
LL, P1
[LL]
(0, 0)
(0, 0)
When note "*2" in the
Plotting Area Chart
UR
LL
P2
P1
Y
Origin
X
(0, 0)
P2
UR
UR, P2
Advertisement
Table of Contents
