Adjusting Carburetor For Cutting At Temperatures; Below -10°C; Holding And Controlling The Chainsaw - Stihl MS 194 T Instruction Manual

English
H
NOTICE
If the chainsaw is again used at a low altitude, the engine
may overheat.
► Carry out the standard setting.
► Rotate the high speed screw H clockwise until the engine
delivers optimum power.
11.2 Adjusting Carburetor for Cutting at
Temperatures Below –10°C
The engine will not accelerate properly if the chainsaw is
used at temperatures below –10°C. The carburetor can be
adjusted to obtain normal engine acceleration in such
conditions.
► Start the engine and disengage the chain brake.
► Warm up the engine by opening and closing the throttle for
about 1 minute.
24
NOTICE
Engine power may drop noticeably when the chainsaw is
subsequently used at temperatures above –10°C.
► Carry out the standard setting.
► Rotate the low speed screw (L) a quarter turn
counterclockwise.
► If the saw chain runs continuously or the engine stops:
Adjust idle speed.

11.3 Holding and Controlling the Chainsaw

► Hold and control your saw with your left hand on the
handlebar and your right hand on the top handle. Wrap
thumb of left hand around the handlebar and thumb of
right hand around the top handle.
11 Operating the Saw
L
0458-568-0121-A