Stihl MS 194 T Instruction Manual page 17

6 Assembling the Saw
2
1
► Rotate the nut (1) counterclockwise until the chain
sprocket cover (2) can be removed.
► Remove the chain sprocket cover (2).
► Turn the tensioning screw (3) counterclockwise until the
tensioner slide (4) butts against the left end of the
housing.
7
► Fit the guide bar and chain on the saw and check the
following points:
– Collar stud (5) is located in slot in tail of guide bar (6).
– Peg of tensioner slide (4) engages hole (8) in guide bar
(6).
The guide bar (6) may be either way round. The logo on the
guide bar (6) may also be upside down.
0458-568-0121-A
3
4
5
6
8
7
► Fit the chain on the chain sprocket (7) so that the chain's
drive links mesh with the sprocket's teeth.
► Fit the chain in the bar groove so that the arrows on the tie
straps on the top of the bar point in the direction of
rotation.
► Turn the tensioning screw (3) clockwise until the chain fits
snugly against the bar. Make sure the drive link tangs
engage the bar groove.
The guide bar (6) and chain are seated against the saw.
► Fit the sprocket cover (2) so that it is flush with the saw.
► Fit and tighten down the nut (1).
6.1.2 Removing the bar and chain
► Shut off the engine and engage the chain brake.
► Rotate the nut counterclockwise until the chain sprocket
cover can be removed.
► Remove the sprocket cover.
English
6
6
3
15