Dhcp; Trace Route - EverFocus EN310 User Manual

Use a network cable to connect between the tester and a network device (such as a switch). Tap the
Port Flashing icon to enter the Port Flashing page. Tap the Start button, the tester will send a signal to
the network device to make the LAN port flicker at a special frequency. And then you can find the
corresponding LAN port on the network device connected to the tester.
4.1.5.5

DHCP

The DHCP server can be used to assign a dynamic IP address to IP cameras and other network devices.
Connect a network cable to the LAN port on the tester and then tap the DHCP icon to enter the DHCP
page. Select Start and configure the following network settings. Tap the Save button to start assigning
dynamic IP address. Tap the Refresh button to check your client list.
4.1.5.6

Trace Route

You can use the Trace Route function to determine the path of the IP packet access target. Please note
that the testing result is only for reference. For accurate route tracking results, please use a professional
Ethernet tester.
EN310 4" Touch Screen Test Monitor
24