Ip Discovery - EverFocus EN310 User Manual

To enable the PoE power output function:
1. Ensure the power of the tester is full or more than 80% charged, otherwise, the tester will show "low
power" and "not able to supply power".
2. Ensure the IP camera is PoE supported and has been connected to the LAN port on the tester (refer to
3.2 IP Camera Directly Connection).
3. Go to IP Camera Test > PoE power output
icon to turn on the PoE power output function. A PoE 48V ON info will be displayed on the top-left
corner. The tester's PoE maximum power output is 24W.
4. To turn off the PoE power output function, tap the PoE icon again.

4.1.2 IP Discovery

Tap IP Camera Test > IP Discovery
automatically search for the IP cameras. With the IP Discovery app, you don't need to know the first two
digits of camera's IP address. The tester can auto-scan the whole network segment IP, and auto-modify
tester's IP address.
Local IP: Displays the tester's IP address. The tester can automatically modify its IP address to the same
network segment of the searched IP cameras.
Discovery IP: Displays the searched IP cameras' IP address.
to enter the PoE power output page. Tap the PoE
to enter the IP Discovery app. You can use this app to
13
EN310 4" Touch Screen Test Monitor