HP ProLiant MicroServer Maintenance And Service Manual page 49

To remove a memory module:
Refer to "Remove the System Board" Section.
1.
Remove any accessory boards or cables that prevent access to the DIMM slots.
2.
Remove the memory module.
3.
○
Completely open the holding clips securing the module (1).
○
Hold the DIMM module gently and pull it out of the slot (2).
To install a memory module:
Locate an empty DIMM slot on the system board.
1.
If necessary, open the holding clips of the selected DIMM slot.
2.
Remove the memory module from its protective packaging, handling it by the edges.
3.
Install the memory module.
4.
○
Completely open the holding clips securing the module (1)
○
Align the notch on the bottom edge of the module with the keyed surface of the DIMM slot
and then press the module fully into the slot (2).
○
Then, lock the holding clicks to secure the memory module in place (3).
The DIMM slots are structured to ensure proper installation. If you insert a memory module
but it does not fit easily into the slot, you may have inserted it incorrectly. Reverse the
orientation of the module and insert it again.
Removal and replacement procedures 49