HP ProLiant MicroServer Maintenance And Service Manual page 46

Rotate and snap in the PCI holder on the back of the chassis.
11.
Make sure that all components are installed according to the described step-by-step instructions
12.
Verify that you have not left loose tools or other loose parts inside the server.
13.
NOTE: Always carefully release the cables from the factory install cable clip before disconnecting all
cables on the system board and re-insert cables into the factory install cable clip after reinstalling all
cables.
Connect all external cables and the AC power cord to the system.
14.
Close the panel door of the server (11).
15.
Use the HP ProLiant MicroServer key to lock the panel door (12).
16.
Removal and replacement procedures 46