Setting Up The Ipx/Spx; Setting Up The Appletalk - Toshiba GA-1190 Setup Manual

Setting up the IPX/SPX

You can set the IPX/SPX protocol to enable the communication over IPX/SPX.
The IPX/SPX must be configured to enable Novell printing with NetWare server 5.1/6.0/6.5 over
IPX/SPX.
1
2
3
1) Enable IPX/SPX
Select whether the IPX/SPX protocol is enabled or disabled. Please enable this when con-
figuring Novell printing over the IPX/SPX network.
2) Frame Type
Select the desired frame type for IPX/SPX.
- Auto Sense — Select this to use an appropriate frame type that the equipment found
first.
- IEEE 802.3/Ethernet II/IEEE 802.3 Snap/IEEE802.2 — Instead of "Auto Sense", select
the frame types to be used from these options.
3) Actual Frame
This displays the actual frame type of the equipment.

Setting up the AppleTalk

You can set the protocol to enable communication over AppleTalk. The AppleTalk must be con-
figured to enable AppleTalk printing from Macintosh computers.
1
2
3
1) Enable Apple Talk
Select whether the AppleTalk protocol is enabled or disabled. Please enable this when con-
figuring AppleTalk printing.
2) Device Name
Enter the device name of the equipment that will be displayed in the AppleTalk network.
3) Desired Zone
Enter the zone name where the equipment will connect — if required. If you leave an aster-
isk in this field, the equipment will connect to the default zone.
Setting up Network Settings (Printing Function) 89