luminii Optic Arts KM Series Installation Instructions

KM, KS, KXL & KL Channel -
Models KMC-XX, KSC-XX, KXLC-XX, & KLC-XX
Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
1
fixture
1.1
4" every 30"
surface
Note:
Prior to install, 24VDC power must be present for wiring. Also
review and account for all parts necessary to install properly.
1.1 Snap the lens into the channel, then align & center the channel to the
determined location. Then make any reference marks if needed to install
the channel, reference step 3 for mounting options.
3
3.1 Secure the channel to the surface by either mounting directly with
screws or using mounting brackets.
a. If mounting channel with screws:
the channel followed by screwing directly to the surface.
b. If mounting channel with brackets :
install a bracket 4" from each end, followed by installing one every
30". Then secure, by screwing through the bracket to the surface.
For adjustable mounting brackets
end, followed by installing one every 30". Then secure, by slightly
loosening the 2 screws on the side of each adjustable bracket.
Then secure, by screwing through bracket to the surface. Then
rotate to the desired position, followed by tightening the side
screws.
FIXED BRACKET
30" maximum spacing
of mounting brackets
mounting brackets
3.1
#4 flat head
wood screws
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Installation Instructions
mounting
bracket
4"
Make counter sunk holes through
For fixed mounting brackets ,
, install a bracket 4" from each
MOUNT EXTRUSION
WITH MOUNTING BRACKETS
2
lens
2.1
channel
Caution:
Safety equipment is recommended, when modifications are being
made to the channel & lens.
2.1 Extrusion & lens can be cut in the field. Using the proper blade for
aluminum, cut to the desired length.
drill through countersink
channel for the holes
mounting
holes
channel
STEP A
3.1
30.0"
4.0"
channel
MOUNT CHANNEL
WITH SCREWS
loosen screws
30" maximum spacing
of mounting brackets
Page 1 of 2
2.1
miter saw
tighten screws below
channel surface
before installing LineLED
STEP B STEP C
30.0"
install #4 flat head wood
screws a maximum 30"
apart minimum of 2
screws per channel.
ADJUSTABLE BRACKET
flathead screw
3.1
REV0.4 02192020
4.0"