Advertisement
-
Tove T-Grid
Installation Instructions
Models TOVE-G-XX
Please read all instructions prior to installation and keep for future reference!
1. PRODUCT TO BE INSTALLED BY A QUALIFIED
ELECTRICIAN.
2. MORE THAN ONE PERSON IS RECOMMENDED FOR THIS
INSTALLATION.
3. SUITABLE FOR DRY LOCATIONS
1
t-grid
tile
width
4-3/8"
4-3/8"
grid width for fixture
NOTE: When laying out the t-grid configuration on the ceiling, each
fixture requires 4-3/8" x length for the fixture to fit properly.
3
T-grid
CAUTION: Make sure the hanger wire is secure to each endcap. Make sure to tie the end of the wire back through the first loop, bend the end of the wire up
to prevent the wire from untwisting.
4
4.1
power
j-box
T-grid
4.1 Use page 4 wiring diagram as reference, and make all the nessary wiring.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
4. TYPE IC
5. INHERENTLY PROTECTED
1.1
fixture
length
tile
width
endcap
suspension cable
conduit
fixture 1
Page 1 of 4
2
2.1
t-grid
2.1 Install hanger wire (not provided) to
the fixture. Carefully bring the fixture to the
back of the t-grid area, followed by placing
the fixture on the t-grid. Additional
information below.
#12 guage wire hanger
(2X) Ø 0.20 hole
Ø 0.15 hole
joining
j-box
fixture 2
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
suspension
cable
fixture
REV0.2 04132018
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for luminii TOVE-G Series
Summary of Contents for luminii TOVE-G Series
- Page 1 T-grid fixture 1 fixture 2 4.1 Use page 4 wiring diagram as reference, and make all the nessary wiring. REV0.2 04132018 *LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE...
- Page 2 Finally tighten the set screws on the plate bracket using the provided Allen wrench. 6.3 Secure LED board back into housing and secure the 4 screws back into place. Repeat for all remaining sections. REV0.2 04132018 *LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE...
- Page 3 A.3 Snap the new modules clips into the fixture followed by tightening screws B .3 Snap lens back into the housing. on the sides. REV0.2 04132018 *LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE...
- Page 4 (tp) test switch/pilot light must be connected to the battery during installation to work. By just connecting the terminal connector to the battery. REV0.2 04132018 *LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE...
Need help?
Do you have a question about the TOVE-G Series and is the answer not in the manual?
Questions and answers