Printing Problems; The Machine Does Not Print; Does Not Blink.); The Machine Does Not Print. (On Line Indicator ( ) Was Blinking.) - Toshiba e-STUDIO161 Operator's Manual

TROUBLESHOOTING

PRINTING PROBLEMS

In addition to this section, troubleshooting information can also be found in the README files for each of the
software programs. To view a README file, see the "Printer Driver Setup Guide".
Problem

The machine does not print.

(ON LINE indicator (
blink.)
The machine does not print.
(ON LINE indicator (
blinking.)
44
The machine is set to off-line mode.
→ Press the [ON LINE] key (
( ).
The machine is not correctly connected with your
computer.
→ Check both ends of the printer cable and make sure you have a
solid connection. Try a known good cable. For information on
cables, see "SPECIFICATIONS".
Copy job is performed.
→ Wait until the copy job is complete.
The port setting is not correct.
→ Printing is not possible if the printer driver port setting is not
correct. Set the port correctly.
) does not
Your machine is not selected correctly in the current
application for the print job.
→ When choosing "Print" from the "File" menu located in
applications, be sure you have selected "TOSHIBA e-STUDIO161
printer displayed in the "Print" dialog box.
The printer driver has not been installed properly.
→ Follow these steps to check and see if the printer driver is
installed.
1 Click the "start" button, click "Control Panel", click "Printers
and Other Hardware", and then click "Printers and Faxes".
(On Windows 95/98/Me/NT 4.0/2000/XP, click the "Start"
button, select "Settings" and then click "Printers".)
2 The "TOSHIBA e-STUDIO161 printer driver icon is not shown.
3 If the icon is shown but you still cannot print, the printer driver
may not have been installed correctly. In this case, delete e-
STUDIO161 Printer Driver and then reinstall it.
The tray size settings are not the same on the machine
and in the printer driver.
→ Make sure that the same tray paper size is set on the machine
and in the printer driver. To change the tray paper size setting in
the printer driver, see the Software Setup Guide.
The specified size of paper has not been loaded.
→ Load the specified size of paper in the paper tray.
) was
The PAPER SIZE indicator is blinking.
→ When "Use close paper size (user program)" is disabled, the
PAPER SIZE indicator on the operation panel will blink. You can
press the [TRAY SELECT] key (
or load paper in the bypass tray and press the [ON LINE] key (
to begin printing.
→ When "Use close paper size" is enabled, printing will take place
using a size of paper that is close to the size of the print image.
Cause and solution
) to turn on the ON LINE indicator
) to select a tray manually,
Page
29
60
–
Printer
Driver
Setup
Guide
–
–
16
Printer
Driver
Setup
Guide
14
16, 21
)
–