Two-Sided Copying Using The Bypass Tray - Toshiba e-STUDIO161 Operator's Manual

TWO-SIDED COPYING USING THE
BYPASS TRAY
To perform manual two-sided copying, follow these steps.
Example: Copying originals A and B onto each side of one sheet of paper
1
Copy original A.
Copied original A Original A
Copied original A Original A
2
Place original B as shown below.
Original B
Original B
26
Original A Original B
Vertically-oriented
original:
If the original is oriented
vertically, place it in the
same orientation as
original A.
Horizontally-oriented
original:
If the original is oriented
horizontally, place it with
the top and bottom and
left and right sides
reversed with respect to
the placement of original
A.
Copy
3
Turn the copy of original A over, and
without changing the position of the
edge closest to you, insert it in the
bypass tray.
Copied
original A
Original B
Copied
original A
Original B
• Copies made on the back side of paper
Note
should always be made one sheet at a
time using the bypass tray.
• Straighten curled or wavy paper before
using it. Curled paper may cause
misfeeds, creases, or a poor-quality
image.
4
Select the bypass tray with the [TRAY
SELECT] key (
the [START] key (
The copy is delivered to the paper output tray.
Insert the paper all the
way in.
), and then press
).