Toshiba e-STUDIO161 Operator's Manual page 23

4
Squeeze the lock lever of the front
guide and slide the front guide to
match the width of the paper, and
move the left guide to the appropriate
slot as marked on the tray.
• The front guide is a slide-type guide. Grasp the
locking knob on the guide and slide the guide to the
indicator line of the paper to be loaded.
• The left guide is an insert-type guide. Remove it and
then insert it at the indicator line of the paper to be
loaded.
• When using LD sized paper store the left guide in the
slot at the left front of the paper tray.
5
Press the [START] key (
the [PAPER SIZE ENTER] key ( ).
Affix the paper size label for the paper size
Note
selected in step 3 to the label position on the
right end of the tray.
) and then
To change the paper size
setting of another tray,
repeat steps 2 to 5 after
pressing the [START] key
( ).
BEFORE USING THE MACHINE
Important points when using the printer mode
Make sure that the tray's paper size setting is the
•
same as the tray's paper size setting in the printer
driver. For example, if the tray's paper size setting is
A4-R (LT-R), set "Setting Paper Size" to "A4-R". For
more information, see "CONFIGURING THE
PRINTER DRIVER" (p.12) in the "Printer Driver
Setup Guide".
1
17