Security - Wiznet WizFi630 Serial Command Manual

4.3 Security

Contents OP CMD
DU
Security Status Get <DU>
<GUx_x_x_x_x_x_x_x>
AuthMode_Encrypt[_DefaultKey_KeyLength_K
eyFormat_KeyValue_radiusPasswd_radiusIP_ra
diusPort]
AuthMode: 1(Open), 2(802.1x), 3(Shared),
4(WPA), 5(WPA-PSK), 6(WPA2), 7(WPA2-PSK),
8(WEPAUTO), 9(WPA1WPA2),
Security Control Set GU
a(WPAPSKWPA2PSK)
Encrypt: 0(None),1 (WEP), 2(TKIP), 3(AES),
4(TKIP_AES)
KeyLength: 0(None), 1(WEP64), 2(WEP128)
DefaultKey: 1 - 4
KeyFormat(WEP): 0(Ascii), 1(Hex)
KeyFormat(WPA-PSK): 0(Passphrase), 1(Hex)
Command Syntax
<Sx_x_x_x_x_x_x_x>
AuthMode_Encrypt[_DefaultKey_KeyLength_KeyFor
mat_KeyValue_radiusPasswd_radiusIP_radiusPort]
AuthMode: 1(Open), 2(802.1x), 3(Shared), 4(WPA),
5(WPA-PSK), 6(WPA2), 7(WPA2-PSK), 8(WEPAUTO),
9(WPA1WPA2), a(WPAPSKWPA2PSK)
Encrypt: 0(None),1 (WEP), 2(TKIP), 3(AES),
4(TKIP_AES)
KeyLength: 0(None), 1(WEP64), 2(WEP128)
DefaultKey: 1 -4
KeyFormat(WEP): 0(Ascii), 1(Hex)
KeyFormat(WPA-PSK): 0(Passphrase), 1(Hex)
<S>
Time
Response Syntax
(ms)
16
406
Example
Using When AP/GW Mode,
AuthMode: 1-a
EncryptType: 0-4
Using When Client Mode, Get Security Status
AuthMode: 1,3,5,7 Client/Adhoc Mode: Not Support
EncryptType: 0-3
<S0_0> or <S1_1_1_1_0_12345>
Change Security. It takes time min :
4 , max 10 seconds
Client/Adhoc Mode: Not Support
<GU0_0> or (Caution : it takes more than 4
<GU1_1_1_1_0_12345> seconds to be applied, please
double check execution GU
command after getting response
via DU command.)
Contents
28