Charging The Internal And External Batteries - Fluke OptiView II Series Getting Started Manual

OptiView TM Series II
Getting Started Guide

Charging the Internal and External Batteries

The external battery and AC adapter/charger (hereafter referred to as the charger)
are shipped with every OptiView
internal and external batteries while operating the analyzer.
The internal battery takes approximately 5 hours to fully charge (see note on page
8 about initially charging the batteries). It will take longer if the analyzer is on
while the battery is charging. Figure 5 shows the internal battery charging jack and
charging status LED.
Figure 5. Charging Jack and LED Location for Internal Battery Only
The charging LED states are as follows:
Off
Flashing
Continuous on, solid
12
Charging Jack
Charging LED
10BASE-T
100BASE-TX
Table 3. Red Charging LED States
Status
analyzer. The charger will charge both the
TM
Description
Charger not connected
Charging
Battery is fully charged, AC power
applied
aww02f.eps