Options; Ribbon - Toshiba B-480-QP Owner's Manual

2. SPECIFICATIONS
2.2 Option
Option Name
Swing cutter module
Rotary cutter module
Peel off module
Fanfold paper guide
module
PCMCIA interface
board
Expansion I/O interface
board

2.3 Ribbon

Type Spool type
68 mm ~ 112 mm
Width
600 m
Length
Outer diameter ø90 mm (max.)
Type
B-4205-QM
A stop and cut swing cutter
B-8204-QM Rotary cutter
B-4905-H-QM
This allows use of on-demand (peel-off) operation or to
rewind labels and backing paper together when using the
rewind guide plate. To purchase the strip module, please
inquire at your local distributor.
B-4905-FF-QM
This is a paper guide exclusively used for fanfold paper.
Attaching it in place of the standard paper guide allows the
printer to print on fanfold paper.
B-8700-PC-QM
This board enables the following PCMCIA cards to be used.
* LAN card: 3 COM EtherLink
* ATA card: Conforming to PC card ATA standard
* Flash memory card:1MB and 4MB cards (See Page 7-1.)
B-8700-IO-QM Installing this board allows connection to external device.
NOTES: 1. "On the fly issue" means that the printer can draw and
2. To ensure print quality and print head life use only
3. When using the cutter ensure that label length B plus
4. When rewinding the media onto the take-up spool in
5. Use of rough media for the ribbon saving issue may
3 COM 3CCE589ET (recommended)
print without stopping between labels.
TOSHIBA TEC specified media and ribbons.
inter label gap length E exceeds 35 mm. (i.e. label
pitch should be greater that 35 mm.) (See Page 2-3.)
batch mode, the max. outer roll diameter should be 180
mm.
cause ribbon smudges.
E2-2
ENGLISH VERSION EO1-33007
Usage
® III (recommended)
2.2 Option