Table of Contents
Advertisement
1.6
Documentation, Software Release and Trademarks
Documentation
Version
Trademarks
1070 072 263-101 (01.08) GB
This manual contains information about the operation and installation of the
CL550 programmable logic controller.
Descriptions regarding the COM-MAP module are excluded.
Available manuals:
Manuals
CL550 Configuration and Commissioning,
Software Manual
.
In this manual the floppy disk drive always uses drive letter A:, and the
hard disk drive always uses drive letter C:.
Special keys or key combinations are shown enclosed in pointed brackets:
D Named keys: e.g., <Enter>, <PgUp>, <Del>
D Key combinations (pressed simultaneously): e.g., <Ctrl> + <PgUp>
.
This manual is applicable for the following versions:
Hardware: GG4–9 201
NT4 101
ZS550 301
Con550 202
Software:
Project configurator 1.0
WinSPS 3.01
WinDP 2.01
All trademarks referring to software that is installed on Bosch products when
shipped from the factory are the property of their respective manufacturers.
At the time of shipment from the factory, the installed software is protected by
copyright. Software may therefore be duplicated only with the prior permis-
sion of Bosch or according to the license agreement of the respective
manufacturer.
MS-DOSr and Windowst are registered trademarks of Microsoft Corpora-
tion.
PROFIBUSr is a registered trademark of PROFIBUS Nutzerorganisation
e.V.
I
B
-Sr is a registered trademark of Phoenix Contact.
NTER
US
Safety Instructions
1–7
Language
Order no.
English
1070 072 262
Advertisement
Table of Contents
