Advertisement
f
f
d
e
INSTALLING THE INCLUDED PARTS
a
2
1
c
e
2
d
d
– 5 –
Align the holes in the front wheel 1 with the
holes in the fork end and install the front wheel
1.
Install it in such a way that the disc rotor c does
not touch the disc pad.
Put the lever d of the front axle 2 down in the
direction in which the stamp "OPEN" is visible
and check that the collar e is open.
Install the front axle 2 to the fork end holes
from the left side of the bicycle.
TIP
8 Even if the collar e of the front axle 2 is
inserted with the collar open, it will close when
pressed in.
8 When the collar e is closed, turn the nut f
approximately 1/8 turn counterclockwise while
keeping it pressed in; the collar will then open.
1
Front wheel
2
Front axle
Check that the collar e of the front axle 2 goes
through the hole in the right side of the fork end
and that the collar is actually open.
Turn the nut f while keeping it pressed to pre-
vent the lever d from turning, and tighten it until
there is a little resistance.
Determine the position in which the lever d is to
be fastened, lower it in the direction in which the
stamp "CLOSE" is visible, then fasten it.
1
1
B
Advertisement
