Regulations - Microsoft Xbox 360 Manual

reGuLationS

Statement of Compliance with
eu directives
Hereby, Microsoft Corporation declares that
this product is in compliance with the
essential requirements and other relevant
provisions of Directives 2006/95/EC,
2004/108/EC and 1995/5/EC. The technical
documentation as required by the
Conformity Assessment procedure is kept at
the following address:
Company
Microsoft Ireland
Operations Ltd.
address
Atrium Building Block B
Carmenhall Road,
Sandyford Industrial Estate,
DUBLIN 18
Country
Ireland
telephone +353 1 295 3826
number +353 1 706 4110
disposal of Waste batteries and
electrical & electronic equipment
This symbol on the product or its
batteries or its packaging means that
this product and any batteries it
contains must not be disposed of
with your household waste. Instead, it is your
responsibility to hand this over to an
applicable collection point for the recycling
of batteries and electrical and electronic
equipment. This separate collection and
recycling will help to conserve natural
resources and prevent potential negative
consequences for human health and the
environment due to the possible presence of
hazardous substances in batteries and
electrical and electronic equipment, which
could be caused by inappropriate disposal.
For more information about where to drop
off your batteries and electrical and
electronic waste, please contact your local
city/municipality office, your household
waste disposal service, or the shop where
you purchased this product. Contact
weee@microsoft.com for additional
information about WEEE.
This equipment is intended to be used in all
EU and EFTA countries.
This Equipment is for indoor use only.
PR OPRIET AR Y NO TE P AR T NUMBER DESCRIPTION
THE INFORMA TION CONT AINED HEREON IS CONFIDENTIAL, IS SUBMITTED IN
CONFIDENCE, AND IS PROPRIET AR Y INFORMA TION OF MICROSOFT CORPORA-
TION, AND SHALL ONL Y BE USED IN THE FUR THERANCE OF , THE CONTRACT OF
SCALE DRA WN BY / D A TE
WHICH THIS DRA WING FORMS A P AR T , AND SHALL NOT , WITHOUT MICROSOFT
1:1
CORPORA TION Õ S PRIOR WRITTEN APPROV AL, BE REPRODUCED OR IN ANY W A Y Lawrence / 07.03.09
USED IN WHOLE OR IN P AR T IN CONNECTION WITH SER VICES OR EQUIPMENT
HEREON MA Y NOT BE DISCLOSED T O A THIRD P AR TY WITHOUT CONSENT OF
SOFTWARE / VERSION A RTWORK NUMBE R
MICROSOFT CORPORA TION, AND THEN, ONL Y PURSUANT T O A MICROSOFT
Illustrator CS2
APPROVED NONDISCLOSURE AGREEMENT .
This product is for use with NRTL-listed (UL,
CSA, ETL, etc.) and/or IEC/EN 60950
compliant (CE marked) Information
Technology equipment.
Laser Specifications
Caution
Use of controls or adjustments, or
performance of procedures other than
those specified herein may result in
hazardous radiation exposure.
This device complies with International
Standard IEC 60825-1:2007:03 for a Class 1
laser product. This device also complies with
21 CFR 1040.10 and 1040.11 except for
deviations pursuant to Laser Notice No. 50,
dated June 24, 2007.
The following Class 1 laser label is located on
the foot of the sensor.
COL OR SPECIFICA TIONS
REVISION
A
27