Connecting The Sensor To The Patch; Preparing The Skin - ZOLL CMCT Monitoring System Instructions For Use Manual

5.1.3 CHARGING THE GATEWAY – FIRST USE AND EVERY DAY
1. Place the Gateway on the Charger in its designated area.
2. The Gateway screen should light up and display it is being
charged. Once removed from the Charger, the Gateway
screen will display battery status in percent.
3. The Gateway, typically, takes about three hours to charge.
See Figure 9.
5.2

PREPARING THE SKIN

IMPORTANT: This step ensures good adhesion to skin.
1. Remove your bra/ undershirt.
2. If hair is present, trim hair at the Patch location indicated by your physician. See images
below.
3. Use provided Prep Wipes to clean area where Patch will be applied and allow skin to
dry.
CMCT Monitoring System
Instructions for Use
Figure 10: Trimming area
Figure 9: Charging the
Gateway
Page 14 of 31