Power connector cable (DC-in)
Table 6-13
Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the optical drive (see
3.
Remove the bottom cover (see
4.
Remove the battery (see
Remove the power connector cable:
1.
Remove the two Phillips M2.5 × 6.0 screws from the right display hinge (1), and then rotate the hinge up
from on top of the power connector (2).
2.
Disconnect the power connector cable from the system board (3).
3.
Remove the power connector cable from the computer (4).
Reverse this procedure to install the power connector cable.
(Preparation for disassembly on page
Optical drive (select products only) on page
Bottom cover on page
Battery on page
31).
25).
26).
29).
Component replacement procedures
Spare part number
L22528-001
47