Memory - HP 470 G7 Maintenance And Service Manual

Memory

Table 6-3 Memory module description and part number
Description
Memory module, 8 GB
Memory module, 4 GB
Before removing the memory modules, follow these steps:
1. Prepare the computer for disassembly
2. Remove the optical drive (see
3. Remove the bottom cover (see
4. Remove the battery (see
Remove the memory modules:
1. Spread the two retention clips outward (1) until the memory module tilts up at a 45° angle.
2. Grasp the edge of the memory module (2), and then gently pull the module out of the slot. Use the same
procedure to remove both memory modules.
IMPORTANT:
Do not touch the components on the memory module.
To protect a memory module after removal, place it in an electrostatic-safe container.
Install the memory modules:
IMPORTANT:
not touch the components on the memory module. Do not bend the memory module.
1. Align the notched edge of the memory module with the tab in the memory module slot (1).
2. Press the module into the slot until seated (2).
Optical drive (select products only) on page
Bottom cover on page
Battery on page
To prevent damage to the memory module, hold the memory module by the edges only.
To prevent damage to the memory module, hold the memory module by the edges only. Do
(Preparation for disassembly on page
29).
31).
Spare part number
937236-855
L10598-855
25).
26).
Component replacement procedures 33