4 Replacement Procedures
4.11 Speaker/Fingerprint sensor board
Removing the Speaker/Fingerprint sensor board
To remove the speaker/fingerprint sensor board, follow the steps below and refer to Figure 4-
17 and 4-18.
1. Remove the following screw and lift up the SP FPC.
•
2. Disconnect the speaker cable from the connector CN7 on the SP FPC and remove
the speaker holder from the slot.
3. Remove the speaker from the speaker holder.
4. Disconnect the SP FPC from the connector CN6170 on the system board and
connector CN950 on the fingerprint sensor board to remove.
M2×3C S-FLAT HEAD
Speaker
Speaker holder
4-28
[CONFIDENTIAL]
M2×3C
S-FLAT HEAD screw
CN7
Figure 4-17 Removing the speaker/SP FPC
4.11 Speaker/Fingerprint sensor board
x2
PORTEGE R200 Maintenance Manual (960-519)
CN950
SP FPC
CN6170