Enable Output - FeelElec FY6800 Series User Manual

Enable Output

After completing the parameter settings for the selected waveform, you need to
turn on the channel to output the waveform. When the output is off, the LED
below the corresponding channel button is off; when the output is on, the LED is
on.
The default output of both CH1 and CH2 is enabled at power on, and the LEDs
below the CH1 and CH2 buttons are lit.
The default status can be modified. Press【SYS】button and then press【MORE】
button to set the output status of dual channels.
For CH1 there are two status:
1) Generator is in parameter setting status and current channel selected is
CH1, then press CH1 to switch between output ON/OFF.
2) Generator is in other working status or current channel selected is not
CH1, then press CH1 to make CH1 as channel selected and press CH1
again to switch between output ON/OFF.
For CH2 there are two status:
3) Generator is in parameter setting status and current channel selected is
CH2, then press CH2 to switch between output ON/OFF.
4) Generator is in other working status or current channel selected is not
CH2, then press CH2 to make CH2 as channel selected and press CH2
again to switch between output ON/OFF.
FY6800 Series User's Manual
23