Installation And Adjustment - Dawlance DWT 260 C LVS+ User Manual

Cautions
Do not put hands into the working machine.
It is dangerous even if the speed is very slow.
Take special care of the children, and forbid
them to climb on the washing machine.
Do not overload the appliance or put any hot
goods (such as the kettle with hot water) on the
washing machine.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Any objects such as coins, safety pins, nails, screws, stones or any other hard, sharp material can cause extensive damage and
must not be placed into to the machine.
Before washing, please ensure the tap is open and the inlet hose is installed properly.
It is suggested to use low foam washing powder.
Before using
Before using
It is dangerous to alter the speci cations or
attempt to modify this product in any way.
Garments which have been in contact with
volatile petroleum products should not be
machine washed.
Petroleum
Thinner
Benzene
Keep the appliance away from direct
sunlight and heat sources like the heater.
03

Installation and adjustment

Please install and adjust the machine according to the requirements of the manual.
It is very important for your safety and correct operation.
Unpacking
Unpack the carton and take out the bottom panel.
Open the top lid of washing machine and take out all of the accessories.
Remove all wrappers, including the polystyrene base.
You are advised to keep all the packaging for reuse in case the machine is to be
transported again.
Installing the bottom cover
Let the back of washing machine incline forward, make
the side of bottom cover with sticker description back to
washing machine, insert to the bottom of washing machine
along the direction of arrow.
Remove two xing clamp by scissors, insert to the
accordingly holes black lines indicating (gently pull
xing clamp should not be pulled out), make the
bottom cover xed on the base.
Positioning
The distance between the washing machine and the wall should be more than 50mm, and the
maximum allowed angle of the shank base of the machine is 1 C. The slanting or rough ground may
cause unstability or the operation to stop, please adjust it with the following methods:
Horizontal checking
Observe, if the water bubble in balancing apparatus
is in red circle or not. In red circle, it is horizontal.
Adjust the adjustable foot
1. Lift up the adjustable foot gently, loose the adjustable nut
and twist the adjustable foot.
2. Fasten the nut after adjustment.
3. Set the machine at, and observe again. If the water bubble
is not in red circle, repeat the above procedure, till the water
bubble is in red circle.
Before using
Scissors Fixing clamp
Bottom cover
The base
2
Adjustable
nut
Fasten
Adjustable
Loosen
foot
High Low
04