Emergency Shut Off; Load Reflecting Materials; Prepare System To Paint - Graco RoadLazer RoadPak 24G677 Operation

Operation
Air System Pressure Relief
1. Relieve air pressure in air tank by turning air valve
to OPEN position.
ti16961a

EMERGENCY SHUT OFF

To shut down the entire RoadLazer system, set
POWER ON/OFF on the Programmable Skipline Con-
troller to the OFF position.

Load Reflecting Materials

1. Set POWER ON/OFF on Programmable Skipline
Controller to OFF.
2. Set RoadLazer engine ignition key to OFF.
3. Relieve air system pressure by opening ball valve
until gauge reads 0.
4. Relieve air pressure in bead tank by turning bead
system valve to OFF position.
5. Remove cover from bead tank.
6. Screen reflective materials to prevent debris from
entering tank.
7. Load bead tank with reflective materials.
Set Up Slide Beam and Gun Arm
1. Unlock gun arm clamp and slide beam clamps.
20
2. Pull slide beam to left or right side of vehicle. Lock
slide beam clamps.
3. Remove gun arm from upright stowed position, and
slide to end of boom. Slowly lower gun arm, and
lock into position with clamp.

Prepare System to Paint

Initial Settings
1. Ground RoadLazer ground strap to earth ground.
2. Fill throat packing nut with TSL to prevent prema-
ture packing wear. Do this each time you spray and
store.
Approximate
Fill Level
ti16425a
TI3058A
ti5240a
ti16423a
3A1214D