Rayco RG165T-R Operator, Service, Maintenance Manual page 7

The following specifications shall constitute minimum requirements for a heavy duty self propelled tree stump cutting machine.
Bidders shall show in the right hand column, under "we will furnish", how the unit proposed meets or exceeds this specification.
General
Weight: 5430 Lbs Maximum
Length: 159" Maximum
Height: 68" Maximum (Exhaust), 60" (Hood)
Width: 35" Minimum, 51" Maximum (Tracks Expanded)
Ground Clearance: 7.5" Minimum
Chassis Design: Electrically welded formed, Structural Steel 1/4", 3/8", 5/8", 3/4"
Self-Propel Means: Hydraulic/Planetary Wheel Motor @ each sprocket
Swing Pivot Bearings: 1-3/4" Greased Steel Bushings
Cylinder Pivot Points: 1", 1-1/4", Greased Steel Bushings
Warning Lights: Display includes warning lights and error messages to easily troubleshoot
warnings.
Ground Pressure: 4.03 PSI (ISO 16754)
Engine
Model: Ford 6.2L, V8 liquid cooled, gas
Number of cylinders: 8
Displacement: 379 cu. in
Maximum no load RPM: 2800
Gross HP at maximum no load RPM: 165 HP
Maximum rated torque: 355ft lbs @2250 RPM
Cooling medium: liquid cooled
Air Cleaner: Dry type with Pre-Cleaner
Oil Filter: Spin-on type
Fuel Tank Capacity: 19 gallons
Electrical System: 12 volts/157 AMP Alternator
Safety: Elastometric engine mounts required
Engine: to be operable on (up to) a 30° slope with the cutter wheel in the full up
or down position
Engine: must remain level with machine frame and not tilt upward or downward
while in operation. Also, engine must not move left or right while in operation.
Hydraulic System - Cutter
800.392.2686
Hydraulic Wheel Drive System
Wheel Drive Pump: Gear
Wheel Drive Motors: Axial 2-speed piston motor
RG165T-R Operator · Service · Maintenance
Control Valve: Manifold Type Electronic Control
System Pressure Relief: 3200PSI
We Will Furnish
Cutting Wheel
Wheel Diameter: 28"
Wheel Thickness: 1"
Cutting Wheel Bearings: 2-3/16" diameter double row spherical roller
Cutter Wheel RPM: 730 RPM @ 2800 RPM Engine Speed
Drive Belt: MBL GigaTorque®
Cutting Teeth: RAYCO Super tooth™ forged,
one piece, with tungsten carbide tips.
Cutter Teeth Quantity: 40 Maximum
Belt Guard: Steel, one piece
Chip Retaining Curtains: two ply nylon neoprene, three ply belting grade 2
Cutter Wheel: Must come to a stop in less than three seconds without shutting off e
Cutter Wheel Engagement: Hydrostatic pump. No clutch necessary
Cutting Range (without repositioning)
Below Ground Level: 20"
We Will Furnish
Above Ground Level: 28"
True Cutting Width (NOT ARC): 72-1/2"
Forward - Backward: Self-propelled unlimited
We Will Furnish
Foreword
Page 2 of 4
7