Rayco RG165T-R Operator, Service, Maintenance Manual page 25

Get To Know Your Machine
1. Display Panel LCM
2. Fuel Tank
3. Blade
4. Fuel Tank Fill
5. Cutter Wheel
6. Engine Access Panel (Engine Dipstick and
Coolant)
7. Engine
8. Battery
9. Radiator Cap
10. Radiator
11. Self-Propel Track Drive
12. Manual Machine Control
13. Remote Receiver LCM
14. Hydraulic Oil Cooler
15. Cutter Boom
16. Hydraulic Tank
Before Operating the Machine
BEFORE OPERATING THIS POWERFUL MACHINE,
PLEASE CONSULT THE SAFETY SECTION FOR
VITAL INFORMATION RELATED TO OPERATING.
NOTICE
To ensure the long life and economical operation of
your stump cutter, we highly recommend that the
operator be well instructed in both the operation
and maintenance of this machine.
1. Review all of the safety decals that are placed on the
machine for your safety and convenience. See the Parts
manual for locating all decals on the machine.
2. Make sure that all shields and guards are in place, and
in good condition, prior to operating the machine.
3. Only responsible, properly instructed individuals should
operate this machine. Inexperienced operators must
always be carefully supervised.
4. Check the cutting wheel for damaged, worn or missing
teeth, and replace as necessary.
5. Make sure that no one is working on, underneath or close
800.392.2686
RG165T-R Operator · Service · Maintenance
to the machine before starting the engine or beginning
to move the machine. Make sure that the area is free of
personnel.
6. Check the stumps to be removed for embedded nails,
wire, metal fence posts, and for rocks or other buried
impediments which may become dangerously thrown
or cause unexpected machine movements when
encountered by the cutting wheel.
7. Ensure that everyone in the vicinity is aware of the
DANGER ZONE associated with this machine. (See
diagram above.) Everyone must avoid the DANGER
ZONE at all times when the machine is in operation!
8. Make no alterations or modifications to your Rayco
stump cutter unless requested or recommended by
Rayco Manufacturing Inc.
9. When starting the engine, the machine controls which
cause machine movements must be in the NEUTRAL
or OFF positions, so that machine motion, which may
result in death or severe injury, does not occur.
10. Do not start the engine or move any of the controls if
there is a "DO NOT OPERATE" or similar warning tag
attached to the machine.
Operation
25