Brake belt contact surface ���������������������������������� 11 Chain 1/2“ x 1/8“ ������������������������������������������������� 12 Freewheel sprocket ��������������������������������������������� 13 Spare parts ���������������������������������������������������� 14 Important Read the manual carefully before using the cycle and save it for future use. 2012 MONARK EXERCISE AB, Vansbro, Sweden...
Since the early 1900s, Monark’s cycles have been living proof of precision, reliability, strength and service. These are the reasons why we are now the world leader in cycle ergometers and the market leader in Scandinavia in transport cycles.
Congratulations on your new Ergometer! • Adjustable seat height • Adjustable handlebar with quick release lever The Monark Ergometer model 874 E is a safe, easy- • Stable frame, solid steel tube to-use bike for fitness testing and work tests. It has •...
To adjust the handlebar loosen the quick release lever(2). See fig: Adjustments. NOTE! The handlebar stem should be inserted into the frame tube at least 3 inches (about 8 cm). This measure is marked with “MAX” on the stem(3). Monark 874 E...
Fig: Switch km/miles (1) including the weights in it. The rubber plates are included in the calibrated weight of the 1 kg weight basket. Monark 874 E...
MONARK Fig: Placement of the chest belt Fig: Electrodes on the back of the Fig: Brake cord chest belt (1) Fig: Brake device 1) Stop 2) Cord bracket 3) Tension center 4) Weight basket Monark 874 E...
The base bearing is loose. Contact your dealer for service. Scratching sound is heard when pedalling. Check that the carriage block is taken off and that none of the covers is scratching. There is a click noise and a squeak noise Loosen the chain. when pedalling. Monark 874 E...
EC Directive 1999/44/EC. In short, the crank axle, tighten if necessary. When the the directive states for that your Monark Dealer will Ergometer is new it is important to tighten the be liable for any defects, which existed at the time of pedals after 5 hours of pedalling (4 times per delivery.
The crank bearing is greased and normally requires no supplementary lubrication. If a problem arises, Brake belt contact surface please contact your Monark dealer. Deposits of dirt on the brake belt and on the contact Flywheel bearing surface may cause the unit to operate unevenly and will also wear down the brake belt.
The sprocket should be lubricated with a few drops of oil once a year. Tilt the cycle to make it easier for the oil to reach the bearing. See fig: Lubrication. Fig: Lubrication Fig: Hub assembly Fig: Special remover (Art. No: 9100-14) Monark 874 E...
Need help?
Do you have a question about the Ergomedic 874E and is the answer not in the manual?
Questions and answers