SAFETY AND WARNINGS WARNING! WARNING! When using this appliance always exercise basic safety precautions including the following: Please read the entire set of instructions before installing or using this appliance. Electric Shock Hazard Please make this information available to the person installing the appliance – doing so Failure to follow this advice may result in could reduce your installation costs.
PARTS SUPPLIED PRIOR TO INSTALLATION Fisher & Paykel is not liable for any damage caused by not following these instructions. Please read the instructions carefully. Unpack the rangehood. Ensure the voltage (V) and the frequency (Hz) indicated on the rating plate match the voltage and frequency of the installation site.
PRODUCT DIMENSIONS Power cord location PLAN PRODUCT DIMENSIONS A Maximum overall height of product B Minimum overall height of product C Overall width of product D Overall depth of product E Height of hood F Width of chimney G Depth of chimney H Distance from centre of ducting outlet to back of product I Distance from centre of ducting outlet to side...
VENTING OPTIONS Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled. The rangehood can be installed to operate with the exhaust air ducted externally from the kitchen, or installed to operate with the exhaust air recirculating within the kitchen. Ducted Recirculating For ducted installation it is recommended that 150 mm diameter, rigid or semi-rigid ducting...
ELECTRICIAL REQUIREMENTS PREPARE RANGEHOOD Warning: Failure to install the screws or fixing device in accordance with these instructions may result in an electrical hazards. Place the ducting adapter onto the rangehood and screw it into place using 10mm screws. Rating plate location Before connecting the rangehood to the power supply, ensure the voltage and frequency Remove the filters –...
Page 8
ATTACH BRACKETS AND MOUNTING SCREWS HANG RANGEHOOD Temporarily mark the height of the Hang the rangehood off the upper bottom of the rangehood and the rangehood mounting screws. Hang off centre of the cooktop on the wall the keyhole attachment points on the according to the information provided back of the rangehood then tighten in 'Installation Height'.
ATTACH CHIMNEY PARTS AND ACCESSORIES ITEM REFERENCE NUMBER Semi rigid ducting kit 150 mm (eaves) PD-RHK150E Bend the tabs on the chimney. Semi rigid ducting kit 150 mm (wall) PD-RHK150W Rear view Recirculation carbon filter x2 792481 Recirculation diverter 792560 Place chimney around the rangehood chassis and hang off the chimney bracket.
FINAL CHECKLIST TO BE COMPLETED BY THE INSTALLER Rangehood is correctly installed All connections are secure Connections have not pierced any electrical or water lines within the wall Ducting has not been crushed or bent in any area's ...