Milk Cleaning Cycle - Saeco 10001872 Operating And Maintenance Manual

26 PROGRAMMING THE MACHINE

Milk cleaning cycle

> machine settings > maintenance > milk cleaning cycle
WARNING! DO NOT OPEN THE SERVICE DOOR DURING THE BREWING, DISPENSING,
WASHING OR RINSE CYCLE.
To clean the machine's internal circuits used for preparing milk.
This cycle is proposed after 14 days from the fi rst dispensing of a milk-based beverage. After 14 days, the
"milk circuit washing" message starts fl ashing (see page 13).
Perform the wash cycle as indicated in this section. If the milk circuit washing cycle is not performed,
dispensing milk-based products will be possible for only 7 more days.
After 21 days (the machine warns the user 3 days before the deadline is reached with the message "milk
circuit washing -3"), the "milk circuit washing" message stops fl ashing and appears any time the button
to select a milk-based beverage is pressed.
At this point, the milk circuit washing cycle must be performed, because the dispensing of milk-based
beverages is disabled. (The machine still enables dispensing hot water and coffee).
When the message "milk circuit washing" appears on the display, press the button
instructions on page 26, step 4. The screen will appear as shown in step 9.
Note: Before performing this function make sure that:
1. a large enough container is at hand;
2. the milk container has been adequately cleaned of all milk residue;
3. the water tank contains a suffi cient quantity of water.
THE WASH CYCLE CANNOT BE INTERRUPTED. A PERSON MUST BE PRESENT DURING THE OPERATION.
USE THE PROVIDED MILK CLEANING DETERGENT.
1
machine settings
maintenance
1.
2.
Detergent residue or water may remain in the container during the wash and rinse cycles. In this case, empty the
container and rinse out any residue before fi lling it again.
2
maintenance
milk cleaning cycle
1.
2.
and follow the
3
yes
milk cleaning cycle
1.
2.
Select and press .