Cutting Deck Lift/Lower Problems
Problem
The cutting deck does not lower.
None of the cutting units raises.
Groundsmaster 7210
16222SL Rev C
Possible Causes
• The operator is not fully pressing the seat switch.
• The seat switch or circuit wiring is damaged.
• The lift control manifold solenoid coil S1 or
circuit wiring is damaged.
• A hydraulic problem in the lift/lower circuit
exists; refer to the
Troubleshooting (page
• The lift control manifold solenoid coil S1 or
circuit wiring is damaged.
• A hydraulic problem in the lift/lower circuit
exists; refer to the
Troubleshooting (page
Page 5–19
4–28).
4–28).
Electrical System: Troubleshooting