Table of Contents
Advertisement
SETTING & TEST
40
Installer Setting - E.S.P Function
E.S.P function is setting the volume of each air flow. It is for the convenience of installation. It is
recommended that you should not use this function while using the wireless remote controller.
CAUTION
!
If you set E.S.P incorrectly, the air conditioner may malfunction.
This setting must be carried out by authorized personnel only.
100 unit
* The E.S.P value is already appropriately set when manufactured from the factory, it is recom-
mended that you do not change the E.S.P value.
10 unit
1
Press
button to appear
the screen. mode.
2
Press the
button for
3secs.
3
Press the
button.
4
Set the volume of each air flow
( LOW'MID'HI) by using the
Press the
button to select the air flow.
(The value of E.S.P could be adjusted from 1
to 255.) (The figure on the left shows when
the strong wind's E.S.P value has been set
to 255.)
5
If you press the
will be set.
button on
button.
button, the E.S.P value
Advertisement
Table of Contents
