Installation Premises - Riello Condexa PRO Series Installation, Technical And Maintenance Manual

GENERAL INFORMATION
1.4

Installation premises

The thermal module must be installed in premises used exclusively for the latter conforming to standards and legislation in force
and where combustion exhaust products and combustion air intake is conveyed out of said premises.
Where combustion air is instead taken from the installation premises then the latter must be equipped with suitably sized vents
conforming to standards.
Space required for in line layout (FRONT)
Space required for back-to-back layout (B2B - BACK TO BACK)
9
When installing the boiler, allow sufficient space around it to access all safety and control devices and to permit easy mainte-
nance.
9
The height of the installation room must meet the fire-prevention requirements and current regulations in force in the country
of installation.
9
Check that the electrical protection rating of the thermal module is sufficient for the characteristics of the installation room.
9
If the thermal modules are powered by combustible gas with a specific weight exceeding that of air, the electrical parts must
be positioned at a height exceeding 500 m from the ground.
18