Advertisement
Quick Links
80-9344-0705-010 (7-01)
Combination Door Closer-Holder
and Releasing Device
WITH
Hinge (Pull) Side of
Stop (Push) Side of
Door Application
Door Application
Integral Smoke Detector
CAUTION
For wiring see "Power Track"
"Wiring Instructions"
An incorrectly installed or improperly
adjusted door closer can cause property
damage or personal injury. These instructions
should be followed to avoid the possibility
of misapplication or misadjustment.
NOTE: For special applications a separate door and frame preparation template is packed with these instructions.
Use this instruction sheet for installation sequence and closer adjustments only.
Use of an auxiliary door stop is always recommended.
9/64"
Hex Drive
Socket Screw
Arm Assembly
Power Adjustment Nut
Closer Body
Cover with Insert
Stop (Push) Side
Hook-Up Box Chassis
Hinge (Pull) Side
Slide Track
And Cover
Slide Track
Smoke Detector
Smoke Detector
Advertisement
Related Manuals for Yale Power Track Series
Summary of Contents for Yale Power Track Series
- Page 1 80-9344-0705-010 (7-01) Combination Door Closer-Holder and Releasing Device WITH Hinge (Pull) Side of Stop (Push) Side of Door Application Door Application Integral Smoke Detector CAUTION For wiring see "Power Track" "Wiring Instructions" An incorrectly installed or improperly adjusted door closer can cause property damage or personal injury.
- Page 2 34-11/16 Ref. (881.1) 12-1/16 Hinge or Pivot (306.4) 11-1/4 (285.7) 3-5/8 (92) (482.6) (203.2) For Concealed 2 Holes for Track: 1-7/16 1-1/4 Wiring Only 1/4-20 Machine Screw (36.5) (32) 1-1/8 (29mm) Hole For Conduit 2-3/8 2 Holes for Hook-Up Box (19) 8-32 Machine Screw (60.3)
- Page 3 34-3/16 (868.4) Hinge or Pivot 12-1/16 (306.4) 11-1/4 (285.7) For Concealed Wiring Only (203.2) 1-1/8 (29) Hole for Conduit (25) 3-1/8 2 Holes for Hook-Up Box: (79) (304.8) 8-32 Machine Screw 3 Holes for Track: (482.6) 1/4-20 Machine Screw Ref. – Bottom of Frame Stop 1-1/8 4-3/4 2-5/8...
- Page 4 Insert arm stud into slide block in track. 11/16" Secure by pushing in on the retainer clip that extends from wrench the slide block, until it is flush with the slide block, see illustration on page 2 of these instructions. Spring-Adjustment-Nut Place door in the Hold Open position.