Download Print this page

Yale Power Track Series Installation Instructions page 2

Combination door closer-holder and releasing device with integral smoke detector

Advertisement

Hinge or Pivot
3-5/8
(92)
1-7/16
(36.5)
3/4
(19)
5-1/8
(130)
Fasteners
Opening
8-32 Machine Screw
Metal Frame
1/4-20 Machine Screw
Metal
Door or Frame
Wood or
3/8 Dia. Sex Nut
Composite
Door
1.
Locate and drill 1-1/8" (29mm) diameter hole in frame face
for the conduit.
2.
template:
holes for
holes for
3.
Fasteners" chart above.
4.
toward lock edge of frame and open side facing down.
5.
Units with a 120V to 24V transformer require that
hook-up board be removed from chassis to enable
mounting.
6.
conduit hole openings away from hinge edge of frame.
Place Hook-Up Box straps between frame and
chassis. Special conduit nut supplied to anchor 3/4"
conduit fitting.
Page 2
34-11/16 Ref.
(881.1)
19
(482.6)
1/4-20 Machine Screw
2-3/8
(60.3)
6-3/4
(171.4)
4 Holes for Closer:
1/4-20 Machine Screw
or 3/8 Dia. Sex-Nuts
Fastener Preparation
Drill: #29 [.136" (3.45mm) dia.]
8-32 UNC Tap
Drill: #7 [.201" (5.10mm) dia.]
1/4"-20 UNC Tap
3/8" [.375" (9.50mm) dia.]
through
using above
.
holes for
using "Preparation for
with smoke detector
from hook-up box assy.
with
(203.2)
2 Holes for Track:
1-1/4
(32)
7.
toward lock edge of door and closer valves
Facing
Facing
for
8.
head screw from screw pack.
9.
instructions above.
10.
11.
pushing in on the retainer clip that extends from the slide block
in the track, until it is flush with the slide block.
Attaching Arm Stud to Slide
12-1/16
(306.4)
11-1/4
(285.7)
8
2 Holes for Hook-Up Box
8-32 Machine Screw
• From centerline of pivot point to end
of track and hook-up box is 35-25/32
(909mm)
• Right hand door shown
• Do not scale drawing
• Dimensions are given in inches (mm)
• Closer mounted with sex nuts
requires that door silencers be used
• Minimum ceiling clearance for unit is
2" (50mm)
• Maximum door opening is 110°
RH Door
LH Door
Pinion Flat
Pinion Flat
w
ith spring adjustment nut
for
door
door.
and install 9/64" hex drive socket
using Arm Indexing
in track assembly. Secure by
2
Retainer Clip
80-9344-0705-010 (7-01)
For Concealed
Wiring Only
1-1/8 (29mm) Hole
For Conduit
1

Advertisement

loading

This manual is also suitable for:

Power track p400 ptdPower track 400 ptd