18
Winding a bobbin
Winding a bobbin is quick and easy when you lollow the
directions
below. Always
wind
the bobbin belore threading the machine and needle.
• Push in indent (1) on hand wheel
disco
This will stop the needle Irom
moving.
• Place spool 01thread on spool pino
• SI ide spool: cap (2) lirmly over rim 01 spool to prevent thread tangling.
• Lead thread Irom spool and snap into thread gu
ide
post
(3).
• Wind thread clockwise around Iront 01bobb
in
winder tension disc
(4).
• Pass thread end, Irom inside, through small hole in rim 01bobb
in.
• Place bobbin on
spindle
and push it to the right.
• Holding thread end
,
step on speed controller to run machine until desired amount 01 thread
ls
wound.
(Wind
ing
stops automatically once bobbin is lul!.)
• Cut thread
;
push bobbin to the left and remove it Irom
spindle.
• Trim thread end Irom top
01bobbin.
• Return hand wheel disc to sewing position by pressing on
side
opposite indent.