Commodore AMIGA Introduction Manual page 99

Getting Back Preferences
If you'd like to get back the Preferences settings that came with the original
Workbench disk, select Reset All. If you'd like to get back the last
Preferences settings you saved, select Last Saved.
Using and Saving Preferences
When you're done with Preferences, select one of the gadgets at the lower
right of the window. Select Save if you want your settings to take effect now
and each time you start up the Workbench with the Workbench disk you're
currently using. Selecting Save saves your settings on the Workbench disk.
Select Use if you want your settings to take effect now, but you don't want
to save the settings on the Workbench disk for future use. If you change the
settings, then decide you don't want them to take effect, select Cancel.
Because each Workbench disk keeps its own Preferences settings, different
people can save their own settings on separate Workbench disks. To get
back your settings, just set up the Workbench using the disk on which
you've saved them.
Input/Output Connectors
This section lists pin assignments for several input/output connectors on the
Amiga. The information in this section is highly technical and is intended
only for those expert in connecting external devices to computers. You do
not need this information if you use a cable specifically designed for use
with the Amiga and the add-on you want to connect.
For information about connectors not described in this section, see the
Amiga Hardware Manual.
7-10 Reference