Commodore AMIGA Introduction Manual page 133

205 object not found : A tool or project that the Amiga needs to locate
is not present on the disk. This can happen if (1) you've moved a
tool to a different drawer, then try to open a project created with
that tool (2) you've renamed either the System or Utilities drawer
on the Workbench disk, then tried to open a project created with a
tool that's in the drawer, or (3) the disk containing a tool you need
is not in a disk drive.
210 invalid stream component name: When renaming a tool, project,
drawer, or disk, you have used an invalid character.
213 disk not validated: If a disk light was on when you removed a disk
or reset the Workbench, the information on the disk that was in
that drive may be unusable. This error may also occur if the disk
surface has been damagetl .
214
disk write-protected:
You have asked the Amiga to add
information to your disk when the protect tab is in the protected
pOSItIon. (See pages 3-2 and 3-3 for information about protect
tabs.) Either change the position of the protect tab or use a disk
whose protect tab is in the unprotected position.
218
device not mounted: This error occurs when a tool needs a disk
that is not currently in a disk drive.
221
disk full : There is not enough free storage on the disk to do what
you have requested. Try emptying the Trashcan (see page 4-17) .
If this doesn't work, you must either delete objects on the disk or
use a different disk.
222
file is protected from deletion: A tool, project, or drawer cannot be
deleted because it is protected. Select the icon for the object,
choose Info from the Workbench menu, then change its status to
DELETABLE.
225 not a DOS disk: Either the disk has not been formatted or it is a
Kickstart disk. Use a different disk, or, if you wish to erase all
information currently on the disk, choose Initialize from the Disk
menu.
226 no disk in drive: A tool expected to find a disk in a disk drive that
wasn't there. Insert the disk needed by the tool you're using.
A-24 Appendices