Commodore AMIGA Introduction Manual page 126

NOTE: When you choose Undo Frame, the frame that was saved when
you last chose Snapshot Frame replaces the currently selected frame.
After you choose Undo Frame, the previous contents of the currently
selected frame are no longer available.
Working with Frames
The Icon Editor's nine frames let you work with more than one icon at the
same time. You can also use the frames to keep and compare more than
one version of the same icon. Listed below are techniques you can use
when working with frames.
Copying a Frame
To copy a frame, first select the frame into which you want to make the
copy. Next, choose the frame you want to copy from the submenu that
appears when you point to From Frame in the Copy menu.
Moving the Image within a Frame
To move the image within a frame, choose In-Frame from the Move menu.
In the requester that appears, select the arrows to move the image up,
down, left, or right. Select the Single gadget if you want the image to move
only a single pixel each time you select an arrow. Select Repeat if you want
the image to continue to move if you hold down the Selection button when
you select an arrow.
The square gadget surrounded by the arrows is the Restore gadget. Select
this gadget to put the image back where it was before you chose In-Frame.
When the image is where you want it, select OK. If you change your mind.
select Cancel to get back what you had before you chose In-Frame.
Appendices A-17