Advertisement
Installation Guide -
1. Door Prep
1" Dia.
Edge Bores
2-1/4"
1/8"
Deep
2-1/4"
1"
* Marretta 6 style locks have 6" center to center
bore spacing.
4. Outside Installation
Extension Collar is provided for thin doors.
Install with tail piece
horizontal
Optional extension
collar for thin doors
Plates and grips vary depending on style.
Tubular Monolithic Entry Set - Single Cylinder Deadbolts
2-3/8"
or
2-3/4"
*
5-1/2"
2-1/8" Dia.
Bores
2. Door Jamb Prep
5. Inside Installation
3/16"
Deep
2-3/4"
1/8"
1-1/8"
Deep
1-1/4"
After lock is
installed, tighten
set screw with
hex wrench
provided.
IN4-ENTSETSGMON 04-29-2013
Advertisement
Table of Contents
Related Manuals for Assa Abloy EMTEK Tubular Monolithic Entry Set
Summary of Contents for Assa Abloy EMTEK Tubular Monolithic Entry Set
- Page 1 Installation Guide - Tubular Monolithic Entry Set - Single Cylinder Deadbolts 1. Door Prep 2. Door Jamb Prep 2-3/8" 1" Dia. 3/16” Deep Edge Bores 2-3/4" 2-1/4" 2-3/4” 5-1/2" 1/8" Deep 1/8” 1-1/8” Deep 2-1/4" 2-1/8" Dia. Bores 1" * Marretta 6 style locks have 6” center to center 1-1/4”...
- Page 2 Installation Instructions-Tubular Monolithic Entry Set - Dummy 2 - 3 / 8 " 2 - 3 / 4 " 5 - 1 /2 " Optional Dead Bolt Collar For Brass Only 2 - 1 / 8 " D ia . B o r e s IMPORTANT: Do not remove screws...
Need help?
Do you have a question about the EMTEK Tubular Monolithic Entry Set and is the answer not in the manual?
Questions and answers
How do I replace the spring for the thumb latch return for an Emtek 4211 entryset? When I took it apart, a piece of the spring was broken off of the spring that puts tension on the thumb latch and It no longer releases the strike. The thumb latch just moves loosely up and down.