Timer Setting; To Deactivate The Timer; To Activate The Timer; Sleep Timer Setting - Philips FWM583/55 User Manual

Clock/Timer

Timer setting

The system can switch on to CD, TUNER, or
USB mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is
in progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
1
In standby mode, press and hold
CLOCK•TIMER for more than two seconds
to select timer mode.
➜
The last timer setting starts flashing.
➜
The selected source will be lighted and
flashing.
2
Press CD, TUNER or USB to select the
desired source.
●
Before setting timer, make sure the music source
has been prepared.
CD – Load the disc(s). To start from a specific
track, make a programme (refer to "CD
Operation - Programming the disc tracks").
TUNER – tune to the desired radio station.
3
Press ALBUM -/+
hour for the timer to start.
4
Press TITLE -/+ ¡ / ™ repeatedly to set the
minute for the timer to start.
5
Press CLOCK•TIMER to store the start time.
●
At the preset time, the selected source will play.
To exit without storing the setting
● Press STOP 9 on the system.
Notes:
– When the preset time is reached and the
selected disc tray is empty, the next available disc
will be selected. If all the disc trays are not
available, Tuner will be selected automatically.
– During timer setting, if no button is pressed
within 10 seconds, the system will exit timer setting
mode automatically.
24
5 6
repeatedly to set the

To deactivate the TIMER

●
Press SLEEP/TIMER on the remote control.
➜
The display will show "OFF" and
disappear from the display.

To activate the TIMER

●
Press SLEEP/TIMER on the remote control.
➜
The last set timer information will be shown
for a few seconds and
display.

Sleep timer setting

The sleep timer enables the system to switch to
standby mode automatically at a preset time.
1
In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.
➜
The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™ 120 ™ OFF
™ 15 ...
➜ "SLEEP XX" or "SLEEP OFF" is displayed.
"XX" is the time in minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.
➜ is shown, except for "SLEEP OFF"
SLEEP
mode.
To check the remaining length of time
after sleep timer is activated
●
Press SLEEP/TIMER once.
To change the preset sleep timer
●
Press SLEEP/TIMER again while the remaining
sleep timer is shown.
➜
The display will show the next sleep timer
options.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until "SLEEP
OFF" is displayed, or press STANDBY ON B.
will
TIMER
will appear on the
TIMER