Manual Preset Programming; Tuning To Preset Radio Stations; Changing Tuning Grid - Philips FWM583/55 User Manual

Radio Reception

Manual Preset Programming

1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press PROGRAM.
➜
starts flashing.
PROG
➜
The next available preset number is displayed
for selection.
To store the radio station to another
preset number
● Press TITLE -/+ ¡ / ™ PRESET to select the
desired preset number.
3
Press PROGRAM again to store the radio
station.
➜
disappears.
PROG
●
Repeat steps 1–3 to store other radio stations.
To exit manual preset mode
● Press 9 on the system.
Notes:
– If you attempt to store more than 40 preset
radio stations, "FULL" is displayed.
– During programming, if no key is pressed within
10 seconds, the system will exit the programme
mode automatically.

Tuning to preset radio stations

●
Once you've programmed the radio stations,
press TITLE -/+ ¡ / ™ PRESET to select the
desired preset number.
➜
The preset number, radio frequency, and
waveband are displayed.
18

Changing tuning grid

all versions)
In North and South America, the frequency step
between adjacent channels in the MW band is
10 kHz (9 kHz in some areas).
Changing the tuning grid will erase all
previously stored preset radio stations.
1
Disconnect the system from the AC power
supply (pull out the AC power cord).
2
While holding down TUNER and á on the
system, reconnect the system to the AC power
supply.
➜ The display will show "GRID 9" or
"GRID 10".
Notes:
– GRID 9 and GRID 10 indicate that the tuning
grid is in step of 9 kHz and 10 kHz respectively.
– The FM tuning grid also will be changed from
50 kHz to 100 kHz or vice versa.
(not available for