To Clean The Condenser; Turning The Condenser Locking Levers; Cleaning The Sensors - Fisher & Paykel DH8060P1 Quick Start Manual

Hide thumbs Also See for DH8060P1:

Cleaning the condenser:

If the 'Condenser' indicator light starts to flash this

indicates that the condenser needs to be cleaned. The

condenser should be cleaned after every 100 drying

hours. The light illuminates when you first turn the

machine on, then turns off once the

button has been touched.

To clean the condenser:

1. Switch off the power supply and remove the

power plug before cleaning the condenser.

2. Open the condenser cover.

3. Turn the two condenser lock levers 90 degrees

then pull out the condenser.

4. Clean the condenser with pressurised water

and wait until the water drains.

5. Replace the condenser.

6. Turn the two condenser lock levers to lock the

condenser back in place again. Make sure that

these locks are engaged securely.

7. Close the condenser cover.

• There are humidity sensors in your machine that

detect whether the laundry is dry or not. These

sensors need to be cleaned periodically (we

recommend approximately four times a year).

To clean the sensors:

1. Open the door of your machine.

2. Allow the machine to cool if drying has been carried out.

3. Locate the metal sensors just behind the lint filter.

https://producthelp.fisherpaykel.com/nz/Dry/Dryers/Condensing/DH8060P1/User_Guide_DH8060P1/09_Caring_for_your_dryer

Pulling out the condenser

Location of the humidity sensors

Updated: Fri, 14 Feb 2020 06:11:37 GMT